Midwest Industries Glock Pistol Caliber Carbine Receiver Block - MI-GPCC
Out of stock
- Fits GLOCK® 9mm/.40cal and 10mm/.45cal style firearms
- Compatible with PCCs and handguns (Kriss Vector, Ruger PC Carbine, and Glock® 19/21)
- High-strength polymer construction
- Mounting holes for attachment to bench or alternative work surface
- Securely locks firearm in magwell for maintenance
- Multiple points of contact for vice use
- Weight: 6.7oz
- Height: 7.75”
- Length: 7.75”
- Width: 1.5”
- 100% Made in the USA
DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.
DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks registered by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither Midwest Industries Inc. nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of parts and components that are compatible with GLOCK pistols, parts, or components. For genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.
| Weight | 6.7 oz |
|---|---|
| MPN | MI-GPCC |
| UPC | 812102033936 |
Compliance
NFA (National Firearms Act) compliance is crucial for legal ownership and transfer of regulated firearms and accessories like short-barreled rifles, suppressors, and certain types of ammunition, ensuring adherence to federal regulations to avoid legal penalties and ensure responsible firearm ownership.
Customer Reviews
- Reviews
- Questions
United States
Loose fitting
Fits very loose in both of my Glock style AR-9 lowers (one is CMT, one is Spike's). And the CMT is a pretty tight magwell. If it fit tighter you could at least sand or dremel it down to fit your individual magwell. I might try wrapping in tape or even putting some JBWeld or something and then sanding down to fit. Will work but the gun/lower will be wobbling around which isn't good. Also, it would be nice if the arm flared out wider, below the portion that inserts into the magwell of course, to give more surface area to be gripped by the vise. Works, but could be a lot better.
